Printable View
Ok so I'm following this guide to get Samba installed on a Slax machine. I do the Samba install, (download the source code, ./configure, make, make install) and then the guide tells me to use a samba command, but my shell says it doesn't know any of the commands. Is the samba install more complicated then the standard ./configure, make, make install routine?
shouldn't be, noQuote:
Originally Posted by Rakjavik
however, there isn't a "samba" command
(samba is just a cute name - the actual protocol is SMB - Server Message Block)
samba gets all it's config info from smb.conf file
(default debian location is /etc/samba/smb.conf)
"smbd" is the main binary (usually used with the -D switch to daemonise it)
"testparm" parses smb.conf and reports any errors (mostly syntax and stuff in wrong sections)
"smbstatus" reports the status (connected clients, locked files, etc.)
All these have manual pages
there's also various other commands (setting up samba users, setting passwords etc.), but the above are the main ones
Also, make sure the executable files that Ynot mentioned are in your PATH environmental variable. You can use the slocate command on Slackware iirc to find where those Samba files are located. Just make sure to run updatedb before you use slocate.